Turnstile Installation Instructions for P60 Lexan Arm Turnstile

Printable version of the turnstile Insallation guide
P60 Installation Guide.doc      P60 Installation Guide.txt

Prior to installation

  • Verify floor level +/- 1/8 inch.
  • Determine rotation of unit
  • Place rotor by the service yoke panel
  1. Place packing foam, to protect aluminum finish during layout, on the floor in the location the turnstile will be placed.
  2. Place canopy on foam aluminum clad side down.
  3. Center punch all " holes and 2" center hole.
  4. Mark on floor which " holes will use the hollow mounting tubes. The hollow tube is used to run card reader wires.
  5. Remove the canopy and protect from damage.
  6. Drill " holes, using a 7/8" bit and no more than 3" deep. Completely clean out concrete dust from holes.
  7. Take one yoke panel with shipping straps still attached and place in each set of holes to check for accuracy.
  8. Prepare LiquidRoc 300 per instructions on package. Pour LiquidRoc 300 into holes, all except for the service pin location,1/3 of the way up hole.
  9. Remove bottom shipping strap and nuts from yoke panels. Insert yoke panels in holes. Clear away any excess epoxy around the service yoke pivot point.
  10. Remove shipping straps and nuts from the top of the yoke panels. Install canopy aluminum side down. Bolt down using the nuts from the shipping strap.
  11. Attach canopy to wall at each end to stabilize. Check for level.
  12. Center bearing assembly on 2" hole. Mark the holes for 3/8" concrete anchors. Clean holes. At this point the unit should be stabilized and level, and now rotor installation can begin.
  13. Attach bearing cup to floor using 3/8" concrete anchors. Install bearing assembly on rotor. *IMPORTANT REMOVE ROTOR FROM SHIPPING CRATE AND PLACE IN VERTICAL POSITION WITHOUT PUTTING STRESS ON LEXAN PANELS. THIS PROBABLY REQUIRES 4 PEOPLE TO ACCOMPLISH.
  14. Slide rotor in to center and lift slightly to place bearing in the bearing cup. Rotate rotor until one arm is pointing to the middle yoke panel. Install control head.
  15. Wire a duplex outlet to the canopy for plugging in the power supply.
  16. Wire card reader (if necessary)
  17. After all wiring has been completed attach the barrier sections and aluminum canopy wrap.

P60 turnstile

P60 turnstile footprint

turnstile assembly

 

   
   

 

Home | Monitor Turnstiles | Tiffany Turnstiles | Security Full Height Turnstiles | Venue | PassThru Turnstiles

News | About Us | Technical Documents | Links | Contact Us

sales@sentronicinternational.com

Phone: 330-225-3029 Fax: 1-330-225-3009

   
   

2004-2009 Sentronicinternational
All Rights Reserved
Valid XHTML 1.0!
Valid CSS!